This wasn’t even after an upgrade, just a reload, but the below messages were displayed before an unmounts and reboot of the switch:
Start type: SRV_OPTION_RESTART_STATELESS (23)
Death reason: SYSMGR_DEATH_REASON_FAILURE_SIGNAL (2)
Last heartbeat 0.00 secs ago
Exit code: signal 11 (no core)
1) … Continue reading
Today we came across an issue where an SRX had very high CPU usage. After a bit of digging it turned out to be the httpd process which runs jweb.
“show chassis routing-engine” outputs like the below output normally (below is not actual output from the box with a problem … Continue reading
This caused headaches as it needed slightly different configuration to normal. ip mtu not being set here was the cause of things sort-of-but-not-quite-working.
Normally with Cisco to Cisco over IPSEC we’d add “ip tcp adjust mss-1392” to the Tunnel interfaces either side.
This is the config that worked … Continue reading
As per title, do NOT install/upgrade OMI agent on NNMi boxes to v12, as this will overwrite files in the /opt/OV/nonOV/perl directory. NNMi9 relies on Per 5.8.8 however 5.16.0 files will be installed when the OMI agent is installed.
Likely the first issues you will see will be NNMi self … Continue reading
I had to update the TACACs server details on an old OmniPliance which proved to be quite confusing. I found the location of the settings but each time we restarted the service it reverted back to the way it was.
Quite a simple solution in the end… The procedure … Continue reading